Trim then extends the curves that intersect with the cutting curve and deletes all non intersecting curves that are in the cutting side.
Steps
1. Download this file and open it in Rhinoceros 7®.
2. Run the command 'Extend and Trim'.
3. Set the options as intended.
4. Select the red curve as the 'Closed Cutting Curve'.
5. Select all the green curves as 'Curves to Extrim'.
6. Select any location to set the 'Cutting Side'.
Command options
ExtendDistance: Set the distance to extend the curves that intersects with the cutting curve. ExtendType: Set the mode how the curves that intersects with the cutting curve will be extended.
Notes
- This command uses apparent intersections and is CPlane sensitive.
