1. Run the command 'Mold Block'.
2. Set the options as intended.
3. Select the location for the mold center.
Command options
Height, Length and Width: Mold dimensions. CornerType: Specifies the type of corner for the mold. Chamfer: Changes the mold corners chamfer distance (Available if CornerType is set as chamfer). Radius: Changes the mold corners fillet radius (Available if CornerType is set as fillet). Properties: If the active layer, or any children, matches with any layer set in the Options > Assemblies > Parts, this option is enabled and then you can set the output properties for the command object(s).
