1. Download this file and open it in Rhinoceros 7®.
2. Run the command 'Curve Morph'.
3. Set the options as intended.
4. Select the green curve as 'Destination Curve'.
5. Select the red curve as 'Origin Curve'.
6. Select the blue objects as 'Objects to Morph'.
Command options
Control Step: Distance between control points. Tolerance: Degree of accuracy required. Deformation: This option is only available in scripting.
Accurate; Makes the deformation slower to update and may result in denser objects.
Fast; Creates objects that have fewer control points and are therefore less accurate.
Notes
- Both planar and 3D curves are allowed.
- For optimal results use Periodic NURBS curves (SubD friendly).
- This command is available in scripting and interactive mode.
- This command is not CPlane sensitive, uses World Top CPlane.
- The 'Deformation' option is only available in scripting. The interactive mode uses 'Deformation=Accurate'.
