Creates a curve representing the middle of the bottom curve.
Steps
1. Download this file and open it in Rhinoceros 7®.
2. Run the command 'Bottom Middle Curve'.
3. Set the options as intended.
4. Select the curve as the 'Bottom Curve'.
Command options
Layer: If is set to 'Input', the axis line will have the same layer of the selected object. Color: If is set to 'Input', the axis line will have the same color of the selected object. Linetype: If is set to 'Input', the axis line will have the same linetype of the selected object. ExtendDistance: Set the extend distance for both sides of the curve.
Notes
- Both planar and non-planar curves are supported as 'Bottom Curve'.
- For non-planar curves, this command is CPlane sensitive.
- For optimal results use Periodic NURBS curves (SubD friendly).
- Multiple curves can be selected.